Search results
Jump to navigation
Jump to search
- [[Internal EEPROM]]115 bytes (11 words) - 09:36, 24 January 2013
- * U1: ATtiny45 or ATtiny85 (pre-programmed, internal oscillator @ 1MHz) ...y and fit it in a small plastic enclosure. The enclosure I chose had small internal rails, between which a circuit board can be held. I was hoping that the enc13 KB (2,121 words) - 22:55, 2 June 2022
- [[File:0145 EEPROM programmer schematic.png]] The Arduino based EEPROM programmer, using two 74HC595 serial shift registers:63 KB (10,390 words) - 01:29, 13 December 2021
- ...es. Press and hold the button for about 5 seconds to store the new ID into eeprom. ...are currently does not detect an out of range value and may cause the read-eeprom-value to fail. Whether this affects further operation of the board is unkno10 KB (1,531 words) - 08:21, 2 January 2014
- ...ve to work on this part at a later stage. There is a possibility to use an internal 1.1V reference voltage. This is a feature inside the ATtiny84. All that's r ...up the t84 at intervals, but it turns out these intervals are depending on internal clock speed and without a crystal they can be very inaccurate. I decided no31 KB (5,437 words) - 23:45, 10 June 2019