Surface Mount FETs compared

From wikipost
Revision as of 19:50, 10 December 2019 by Admin (talk | contribs)
Jump to navigationJump to search

One particular electronics component that I often found difficult to pick for my projects is the venerable MOSFET. The FET is part of the Transistor family of semiconductors. There are many types of transistors, but they basically fall in one of these three broad categories:

  • Current-driven: BJT (Bipolar Junction Transistor)
  • Voltage-driven: FET (JFET and MOSFET)
  • Other (e.g. phototransistors)


BJTs and FETs can be used for either switching or amplification, but generally one type performs better than the other.

Consider:

  • BJTs require a constant current flow through the base in order for the transistor to open. This base-driven current flow can easily exceed the current rating of microcontroller ports and additional drivers (BJTs or FETs) are often required to enable higher drive currents. BJTs however outperform FETs in terms of amplification factor. Although BJTs can be used for switching purposes, they are not the most obvious choice when we need to save overall power consumption.
  • FETs are voltage driven and can usually be connected directly to microcontroller ports. There is the factor of inrush-current if a FET has a high capacitance, but a simple series current-limiting resistor is sufficient to deal with that. FETs may also need to be selected to be compatible with the logic-level (TTL) voltages and may therefore also require additional drivers to enable higher (or lower) drive voltages. They are however a better choice than BJTs when it comes to low-power switching.