Admin at 00:21, 19 January 2015

2015-01-19T00:21:17Z

New page

This page is about the adventures of making a CNC machine from old inkjet printers, stepper motors and MDF. The aim is to have a machine that is precise enough to use for making printed circuit boards without using the liquid-etching techniques.

I loosely base my design on the MicroCarve series of CNC machines that have had good reports about precision, ease of assembly and low cost.

[[File:MV3025.jpg|thumb|none|150px|Inspiration: The Microcarve MV3]]

The process will roughly consist of the following steps:

* salvage the machined rods and print-head carriages from old printers (need at least 6 rods)

* cut the sides and cross bars from MDF sheet

* make a Y-axis table with a threaded rod and bolt

* attach the cross bars to the sides

* attach the Y-axis assembly to the cross bars

* make an X-axis table with a threaded rod and bolt

* attach the X-axis assembly to the sides

* make a Z-axis dremel tool-holder table with a threaded rod and bolt

* attach the Z-axis assembly to the X-axis table

* find/buy/salvage 3x stepper motors and connect to the threaded rods

* make/design/buy stepper motor driver boards

* interface 3D modelling software to the stepper motor driver boards

2015 - January

Finally our neighbourhood was up for bulk-waste collection again. This time around I made a more serious effort in picking up some discarded inkjet printers and there were plenty.

[[File:Old-inkjet-printers.jpg|thumb|none|300px|discarded inject printer ready for salvaging parts]]

The following printer models had some useful parts:

* Lexmark Z640 (1x 7mm rod with ink carriage)

* Canon MP370 (1x 8mm rod from the scanner, 1x 8mm rod from the printer)

CNC-machine - Revision history

Admin at 00:21, 19 January 2015